3D Models

A pipe bend, scanned with Artec Micro. It took only two scans using the simple trajectory to get the full shape of the pipe.

Plaster cast of teeth • Micro

This object is considered as «large» for trajectory purposes. Although we used only a «simple» type of trajectory, with fewer frames, all of the intricate curvatures were successfully captured.

Plastic bolt • Micro

Despite its complex geometry and reflective surface, this 1.5 cm plastic bolt was captured using the ultra-precise Artec Micro in just three scans.

Power drill • Space Spider

Well used Ridgid power drill scanned with the Artec Spider.

Product part • Space Spider

Product part made of plastic. Scanning time was around 5 minutes, and post-processing took about 20 minutes. This is a good example of fast reverse engineering.

Puffer Fish • Space Spider

A taxidermy porcupine fish, scanned with Space Spider. A somewhat challenging object due to its semi-translucent skin and difficult geometry.

Screw • Micro

Small object — big challenge. How do you capture the thread of this 10 mm long screw using a 3D scanner?

Shampoo bottle cap • Micro

The cap was made of semi-transparent plastic and required a bit of dusting with an airbrush. Then it was mounted on the scanner’s rotating platform with a clamp. A couple of mouse clicks — and scanning commenced.

Smart car • Ray

The complete model of this Smart car was created from approximately 10-13 scans taken from various positions around all sides of the vehicle. We also took two scans from below, with the car raised on a car lifter.

Socket cap screw • Micro

This model of a tiny screw was captured with Artec Micro in just 6 minutes.

Starfish • Space Spider

The object has a lot of fine geometry and small complex sections for scanning.

Steering joint • Space Spider

This part has a cylindrical shape, which is difficult for any scanner. But we found an easier way to scan it.

Striped Shoe • Eva

Leather surfaces often reflect the white glare from a scanner's flash. In order to prevent that we slightly tilted the scanner to avoid scanning at a 90° angle.

Textured vase • Leo

To demo Artec Studio’s Photo Texture feature, we combined Artec Leo’s precise geometric scan data with an iPhone camera’s photographs.

Top of hand • Space Spider

A quick scan of the top of the hand with Spider allows you to see the fine details of the skin and nails.

Tower well valve • Eva

An early 1900’s tower well valve scanned on-site with Artec Eva, connected to a portable battery and a tablet.

Transmission • Eva

An old transmission box, scanned with Eva. A good example of a challenging object, since it has a lot of deep holes.

Troll • Leo

This ordinary office Troll was scanned with an Artec Leo 3D scanner. In exchange for the promise of some meaty morsels, the troll agreed to pose for the scanning by leaning on a chair that was later removed during post-processing in Artec Studio.

Turbine • Space Spider

This small turbine was scanned in three passes using a rotating table — this enabled the operator to easily capture all the curves from different angles with less hand motion.

Turkana Boy • Space Spider

Just like the Fox Skull, Turkana Boy skull consisted of two separate parts that were scanned separately, and aligned afterwards.

Werewolf • Eva

Capturing both hair and fur can be quite tricky, but this 3D model of a very furry werewolf, made with Eva, shows that nothing is impossible!

Wooden Box • Combo

This mahogany tissue box holder proved to be an excellent scanning object due to its unique geometry.

WRL 3D models